Watchful problem can answer when changeover of dislocation razor blade and arbor are installed

  • Time:
  • Click:83
  • source:ELAND CNC Machining
The problem dislocation that bit is installed and should notice when changeover and change manage razor blade, knife fills up bit Shi Yingqing and arbor each interface, should make sure interface is mixed without scrap sundry, the surface has protruding to remove bit of Ying Xiuping. The point that already had used should change the fixed position of the flow direction that cut bits to the face. Dislocation knife a short while should make its lean reliably to fixed position face, exert oneself to do sth. when clamp proper, should not be too big (can use the wrench that measure power when necessary) . When clamp, the lathe tool of some structures needs to press bit with the hand, make bit sticks close underside (like prejudicial type construction) . Mat of the razor blade of clamp, knife and arbor 3 person interface should joint does not have aperture, what should note position of point of a knife is good and clingy, must not have light leak appearance, knife mat must not have more become loose. When the problem lathe tool that the attention answers when arbor is installed is installed, its underside Ying Qingjie does not have adhesion content. If use spacer to adjust height of point of a knife, spacer should flat, cannot exceed 3 at most. If inside is mixed outside the fixed position range that flank also must make installation, also answer rub-up. Arbor extends length to ask to fall in contented treatment should as far as possible short, 1 extending length commonly is arbor height.

5 times. If want to extend truly longer ability satisfies treatment to need, also cannot exceed 3 times of arbor height. The problem that the attention answers in using expresses place to show as follows. Problem account measure the cutting tool below the circumstance is normally bad to choose undeserved cutting tool to produce quality with cutting tool form dosage of too poor cutting chooses undeserved and new type selecting to choose the cutting tool with good quality to choose reasonable cutting dosage cutting has oscillatory razor blade to do not have on size error of clamp razor blade too big clamping unit is out of shape cutting tool, notice bit underside stick change the razor blade with high bending strength closely to change bit knife is filled up or arbor cutting creaks acoustical bit underside and knife mat or knife mat and cutter hub are touched secondhand from time to tome disloyal, cutting tool outfit places not firm cutting tool to wear away serious arbor has been extended long, slightness of rigid and cannot work or book wall rigid inadequacy, and clamping apparatus tigidity is insufficient, clip solid is not firm cutting tool of heavy new clothes or razor blade change grind blunt cutting blade to shorten arbor extends length to increase machining complex rigid point of a knife is in sparkle point of a knife or section of cutting blade job has breach cutting tool to wear away serious cutting speed, begin before cutting pouring till cutting tool is exited need not cutting fluid, dry cutting changes the bit with good quality CNC Milling